Installing The External Batteries (Chsgw Small Batt Box) On 9.5" Gateway (Chs2U Gw) Chassis (Au Only); Chsgw Small Batt Box Installation; Figure 3-97 Installing Cover Battery; Figure 3-98 Remove Top Cover Of Battery Compartment - NEC Univerge SV8100 System Hardware Manual

Hide thumbs Also See for Univerge SV8100:

Table of Contents

UNIVERGE SV8100

System Hardware Manual

Insert tabs on cover into holes on CHS LARGE BATT BOX.

Slide the cover left until seated and tighten the screw.

Installing the External Batteries (CHSGW SMALL BATT BOX) on

9.5" Gateway (CHS2U GW) Chassis (AU Only)

An optional, CHSGW SMALL BATT BOX can be installed to provide external

battery power to the CHS2U GW chassis during a power failure. The short-

term battery box will power the system for approximately 10 minutes.

On the battery box compartment, remove the two screws then

lift and set aside the top cover.

Remove the metal support bracket.