Install Grounding On 9.5" Gateway; Install Ac Power Cord 9.5" Gateway Chassis; Install Additional Blades 9.5" Gateway Or Base Chassis; Apply Power To The 9.5" Gateway Or Base Chassis - NEC Univerge SV8100 System Hardware Manual

Issue 9.0
3 - 18

Figure 3-26 9.5" Chassis (Rear View)

2.4.1

Install Grounding on 9.5" Gateway

1. Ensure the 9.5" chassis (CHS2U GW) is powered off and the
AC power cord is unplugged.
2. Ground the chassis by connecting a 14 AWG wire from the FG
lug on the back side of the chassis to an electrical service
ground (Connect to grounding conductor (Less than 10 ohms)).
Refer to
2.4.2

Install AC Power Cord 9.5" Gateway Chassis

Locate the supplied AC power cord and attach to the AC Inlet located
on the back of the chassis [refer to
View)].
2.4.3

Install Additional Blades 9.5" Gateway or Base Chassis

Refer to Chapter
4-3.
2.4.4

Apply Power to the 9.5" Gateway or Base Chassis

Refer to Chapter
4-8.
Figure 3-26 9.5" Chassis (Rear
Figure 3-26 9.5" Chassis (Rear
4, 2.1 Installation and Safety Precautions on page
4, 2.6 Powering Up the SV8100 System on page
UNIVERGE SV8100
View).
Installing the SV8100 Chassis