NEC SL2100 Features And Specifications Manual page 175

ISSUE 1.0
then,
Turn on the Private Call Refuse mode using the service code (PRG 11-10-32) or Programmable
Function Key (code 86).
• To transfer the "Private" Caller ID incoming call to extension 301 as ring pattern 2:
PRG 14-01-27: 1 (reject)
PRG 22-18-01: 1 (extension number)
PRG 22-18-02: 301 (extension 301)
PRG 22-18-03: 2 (ring pattern 2)
then,
Turn on the Private Call Refuse mode using the service code (PRG 11-10-32) or Programmable
Function Key (code 86).
• To transfer the "Private" Caller ID incoming call to incoming ring group 2 as ring pattern 3:
PRG 14-01-27: 1 (reject)
PRG 22-18-01: 2 (incoming ring group)
PRG 22-18-02: 2 (group 2)
PRG 22-18-03: 3 (ring pattern 3)
then,
Turn on the Private Call Refuse mode using the service code (PRG 11-10-32) or Programmable
Function Key (code 86).
• To reject the call with "2142622000" Caller ID incoming call:
PRG 14-01-27: 1 (reject)
PRG 20-07-25: 1 (Enable for COS)
PRG 22-16: 32 (Speed Dial group 32)
PRG 13-02; Group 32: 900 - 919
PRG 13-04-01; Table 900: 2142622000
then,
Turn on the Caller ID Refuse mode using the service code (PRG 11-10-34) or Programmable Function
Key (code 87).
• To transfer the call with "2142622000" Caller ID incoming call to extension 301 as ring pattern 1:
PRG 13-04-01: 2142622000
PRG 13-04-03: 1 (extension number)
PRG 13-04-04: 301 (extension 301)
PRG 13-04-05: 1 (tone pattern 1)
• To transfer the call with "2142622000" Caller ID incoming call to incoming ring group 2 as ring
pattern 2:
PRG 13-04-01: 2142622000
PRG 13-04-03: 2 (incoming ring group)
PRG 13-04-04: 2 (group 2)
PRG 13-04-05: 2 (tone pattern 2)
Conditions
• Caller ID Matching. The SL2100 compares the Caller ID and programmed Speed Dial and allows/
denies as indicated below.
• The Speed Dial table is searched from the starting number and the first match result is used.
• The maximum number of VRS message channels that can be used simultaneously is 16. These
channels are also shared with the voice mail.
• This feature does not work with incoming trunk calls via networking (from another system).
In this case, the refuse/routing program must be programmed in the system that has those trunks.
Routing to the other system's extension is available.
• When PRG 13-04 is used; it will override the setting in PRG 22-02-01: Incoming Call Trunk Setup.
Features and Specifications Manual
SL2100
C
1-161