NEC SL2100 Features And Specifications Manual page 177

ISSUE 1.0
Caller ID Flexible Routing
Program Program Name
No.
13-04-01 * Speed Dialing Number and Name - Number
13-04-03 * Speed Dialing Number and Name - Transfer
Mode
13-04-04 * Speed Dialing Number and Name - Transfer Des-
tination Number
13-04-05 Speed Dialing Number and Name - Incoming
Ring Pattern
Caller ID Refuse for Specific Numbers
Program Program Name
No.
14-01-27 * Basic Trunk Data Setup - Caller ID Refuse Setup
22-16-01 * Private Call Refuse Target Area Setup - Speed
Dial Group Number
13-02-01 * Group Speed Dialing Bins
13-04-01 * Speed Dialing Number and Name - Number
Features and Specifications Manual
Input Data
Maximum of 36 digits (0 ~ 9, ,
*
#, @, P, R)
@ = Wait for Answer Supervision
- ISDN trunks only
P = Pause - Analog Trunk Only
R = Hook flash - Analog Trunk
Only
0 = Not Used (Calls will not be
routed based off a users caller
ID.)
1 = Internal Dial (Calls will be
routed to an internal number
specified in PRG 13-04-04.)
2 = Incoming Ring Group (Calls
will be routed to a ring group
specified in PRG 13-04-04.)
3 = Remote Monitor (Used for
the security feature and not Flex-
ible Caller ID routing.)
If Transfer mode is (Refer to
13-04-03) :
1 = Internal Dial Mode
1 ~ 9, 0, , #, P, R, @
*
P = Pause
R = Recall
@ = Additional Digits when using
ISDN functionality
(Maximum 36 Characters)
2 = Incoming Ring Group
0 ~ 50 (IRG Number)
3 = Remote Monitor
Dial (Up to 8 digits)
0 = Normal System Ring Pattern
1 ~ 4 = Tone Pattern 1 ~ 4
5 ~ 9 = Scale Pattern 1 ~ 5
10 ~ 13 = Tone Pattern 5 ~ 8
Input Data
0 = Disable (CID refuse will not
function.)
1 = Enable
0 ~ 50
0 = No Group Assigned (Caller
ID refuse will not function.)
0 ~ 999 = Speed dial bins 0 ~
999
Maximum of 36 digits (0 ~ 9, * ,
#, @, P, R)
@ = Wait for Answer Supervision
- ISDN trunks only
P = Pause - Analog Trunk Only
R = Hook flash - Analog Trunk
Only
SL2100
Default
No Setting
0
C
No Setting
0
Default
0
0
0
No Setting
1-163