NEC SL2100 Features And Specifications Manual page 905

ISSUE 1.0
Program Program Name
No.
15-03-01 Single Line Telephone Basic Data Setup - SLT
Signaling Type
15-03-03 Single Line Telephone Basic Data Setup - Termi-
nal Type
15-03-09 Single Line Telephone Basic Data Setup - Caller
ID Function
15-03-16 Single Line Telephone Basic Data Setup - Spe-
cial DTMF Protocol Send
15-07-01 Programmable Function Keys
16-01-01 Department Group Basic Data Setup - Depart-
ment Name
16-01-02 Department Group Basic Data Setup - Depart-
ment Calling Cycle
16-01-03 Department Group Basic Data Setup - Depart-
ment Routing when Busy (Auto Step Call)
16-01-04 Department Group Basic Data Setup - Hunting
Mode
16-01-05 Department Group Basic Data Setup - Extension
Group All Ring Mode Operation
16-01-06 Department Group Basic Data Setup - STG With-
draw Mode
16-01-07 Department Group Basic Data Setup - Call Recall
Restriction for STG
16-01-09 Department Group Basic Data Setup - Depart-
ment Hunting No Answer Time
16-01-10 Department Group Basic Data Setup - Enhanced
Hunt Type
16-02-01 Department Group Assignment for Extensions
20-02-09 System Options for Multiline Telephones - Dis-
connect Supervision
20-03-01 System Options for Single Line Telephones - SLT
Call Waiting Answer Mode
20-06-01 Class of Service for Extensions - Class of Serv-
ice for Extensions
20-11-01 Class of Service Options (Hold/Transfer Service)
- Call Forward All
Features and Specifications Manual
Input Data
0 = DP
1 = DTMF
0 = Normal
1 = Special
0 = Disable (Caller ID not dis-
played.)
1 = Enable (Caller ID is dis-
played.)
0 = No
1 = Yes
-
Maximum 12 characters
0 = Normal Routing (Priority)
1 = Easy - UCD Routing (Circu-
lar)
0 = Normal (Intercom caller
hears busy tone.)
1 = Circular (Intercom caller
routes to an idle group member.)
0 = Stop at last member (non-
loop)
1 = Circular
0 = Manual (Ring the extensions
one at a time when the service
code are pressed.)
1 = Automatic (Ring all exten-
sions.)
0 = Disabled (Call will camp on
to the group.)
1 = Automatic (Call follows PRG
22-11-11.)
0 = Disabled (Call will recall.)
1 = Enabled (Call will not recall.)
0 ~ 64800 seconds
0 = No hunting
1 = Hunting When Busy
2 = Hunting When Not Answered
3 = Hunting When Busy or No
Answer
-
0 = Disable (Off)
1 = Enable (On)
0 = Hook Flash (Hooking)
1 = Hook Flash + Service Code
794
1 ~ 15
0 = Off
1 = On
SL2100
Default
1
0
1
0
Refer to the program-
ming manual for the
default values and for
all other available op-
tions in this command.
No Setting
0
0
0
0
0
0
15
0
Refer to Programming
Manual.
1
0
Extension 101 is Class
15 and other Extension
are Class 1
COS 01 ~ 15 = 1
1-891
V