Removing Cable Kit; Accessing Cable Kit - Fujitsu M10 Product Notes

Note - When receiving power from the dual power supply, be sure to disconnect the power
cord after taking notes on the connection position in order to reconnect the cord correctly.

Removing Cable Kit

This section describes the procedure to remove the cable kit.
Enable removal of the cable kit before you remove it. For details, see "Enabling
Removal of Cable Kit."
Caution - Be sure to wear an antistatic wrist strap before handling the components. If
you perform the work without it, the electronic parts and the system may suffer
serious damage. For details, see "1.4 Notes Regarding Static Electricity."

Accessing cable kit

1.
Remove all the power supply units.
For details, see "9.4 Removing Power Supply Unit."
2.
Pull out the cabinet from the rack.
For details, see "5.3.2 Pulling out cabinet from rack."
3.
Open the fan cover.
For details, see "5.3.3 Opening fan cover."
4.
Remove the upper cover.
For details, see "5.3.4 Removing upper cover."
5.
Remove the air duct and the PSU backplane cover.
For details, see "5.3.5 Removing air duct and PSU backplane cover."
Fujitsu M10/SPARC M10 Systems Product Notes for XCP Version 2043 ･ October 2013
124