Fujitsu M10 Product Notes page 42

Table 3-3
Problems resolved in versions prior to XCP 2043 (continue d)
SPARC
RTI No. M10-1
RTIF2-121130- x
001
RTIF2-121204- x
001
RTIF2-121204- x
002
RTIF2-121204- x
003
RTIF2-121204- x
004
Fujitsu M10/SPARC M10 Systems Product Notes for XCP Version 2043 ･ October 2013
30
SPARC SPARC
M10-4 M10-4S Description
x x When you enable and disable
the power supply interlocking
of RCIL, and then enable it
again, the power supply
interlocking of ETERNUS
DX80/DX90/DX410/DX440/
DX8100/DX8700 S2 may not
work.
x x The dynamic resource
management software
(ServerView Resource
Orchestrator) sometimes fails to
register a server to be monitored.
x x If a node of PRIMECLUSTER
stops, node switching does not
occur automatically.
x x When you set or change
environment variables of
OpenBoot PROM by setenv or
nvramrc of OpenBoot PROM, or
by the eeprom(1M) or ldm
set-var commands of Oracle
Solaris, the setting or changes
may not be retained after
recycling the power supply to
the system.
x x When you enable the auto boot
function of the guest domain by
the setpparmode(8) command
of XSCF and then start the
control domain and the guest
domain simultaneously, you
may encounter the situation
where the following error
message is recorded and Oracle
Solaris
cannot be started in the guest
domain.
Code: 20000000-
00ffff0000ff0000ff-
030000020000000000000000
Status: Notice
Occurred: Nov 16 16:
55:25.518 JST 2012
FRU: /UNSPECIFIED
Msg: Boot process
failed
Workaround
When you enable and disable
the power supply interlocking
of RCIL, restart XSCF.
There is no effective workaround.
Register the server to be
monitored again by the
dynamic resource management
software.
There is no effective workaround.
Switch nodes manually in
PRIMECLUSTER.
After you update an environment
variable of OpenBoot PROM,
execute the ldm add-config
command to save the domain
configuration information to
XSCF.
Use the XSCF setpparmode(8)
to disable the auto boot function
of the guest domain, and then
start Oracle Solaris of the
control domain. Then use the
ldm start command of Oracle
VM Server for SPARC to start
the guest domain.
[How to restore]
Use the ldm stop command of
Oracle VM Server for SPARC to
stop the guest domain, and then
use the ldm start command to
start the guest domain.