Fujitsu M10 Product Notes page 49

Table 3-3
Problems resolved in versions prior to XCP 2043 (continued)
SPARC
RTI No. M10-1
RTIF2-130215-
001
RTIF2-130215- x
002
RTIF2-130219-
001
RTIF2-130219-
005
RTIF2-130219-
008
SPARC SPARC
M10-4 M10-4S Description
x After the hardware initial
diagnosis detects a system
board (PSB) error as described
in the following error log, the
PSB may not be degraded but
the physical partition (PPAR)
may be reset repeatedly.
Code: 40002000-
003cff0000ff0000ff-
02000e000000000000000000
FRU: /BB#x
Msg: SB deconfigured (SB-SB
access error)
Code: 40002000-
003cff0000ff0000ff-
02000e010000000000000000
FRU: /BB#x
Msg: SB deconfigured (not
running)
x x Even when policy is set to psb
by the setpcl(8) command, a
unit of resource to be degraded
when an error occurs may not
be a system board but Field
Replaceable Unit (FRU).
x The takeover IP address of an
XSCF cannot be specified as a
value for "IPAddress" or
"SlaveAddress," which can be
set in the management file for a
power supply interlocking
group.
x x If a failure occurs in a
component in a physical
partition (PPAR), the status of
the PPAR in the SNMP MIB is
not updated.
x If you turn on the input power
supply to a SPARC M10-4S
cabinet while a physical
partition (PPAR) is being
powered on in a system that has
multiple PPARs, the SPARC
M10-4S cabinet for which the
input power supply is turned
on may not be recognized by
the master XSCF.
Workaround
Disconnect the PSB where an
error is detected from the PPAR
configuration by using the
deleteboard(8) command.
Disconnect the PSB where an
error is detected from the PPAR
configuration by using the
deleteboard(8) command.
Specify the IP addresses of
XSCF-LAN#0 and XSCF-LAN#1
of the master XSCF and the
standby XSCF for "IPAddress"
and "SlaveAddress," respectively.
There is no effective workaround.
Power on the input power
supply to all the crossbar boxes
and SPARC M10-4S cabinets
that compose the system before
powering on a PPAR.
Chapter 3 Information on Software 37