Fujitsu M10 Product Notes page 48

Table 3-3
Problems resolved in versions prior to XCP 2043 (continue d)
SPARC
RTI No. M10-1
RTIF2-130212-
001
RTIF2-130212- x
002
RTIF2-130212- x
003
Fujitsu M10/SPARC M10 Systems Product Notes for XCP Version 2043 ･ October 2013
36
SPARC SPARC
M10-4 M10-4S Description
x If the power save operation,
which is set by the setpparmode
(8) command, is "enabled," the
following problems may occur.
A hang-up (heartbeat
■
function) in a logical domain
may be unable to be detected.
If the CoD resources of a
■
CPU core are reduced
during system startup (while
a physical partition (PPAR)
is operating), the PPAR may
be powered off.
x x When you check the domain
status by using the
showdomainstatus(8) command
from the XSCF after executing
the ldm add-spconfig command
from Oracle Solaris, "Host
stopped" is displayed for all
domains, including the control
domain.
x x If you execute the testsb(8)
command to a system board
(PSB) that is being diagnosed by
the testsb(8) or diagxbu(8)
command in a different session,
the PSB that is being diagnosed
may enter an abnormal state
and become unavailable.
Workaround
Set the power save operation to
"disabled" by using the
setpparmode(8) command.
When you check the domain
status by using the
showdomainstatus(8) command
from the XSCF after executing
the ldm add-spconfig command
from Oracle Solaris, "Host
stopped" is displayed for all
domains, including the control
domain.
Confirm that the PWR of the
PSB to be diagnosed is "n" and
that Test is not Testing by using
the showboards(8) command
before executing the testsb(8)
command.
If a PSB becomes unavailable,
power off the entire system and
then power it on again.