Fujitsu M10 Product Notes page 53

Table 3-4
Problems that might occur in any versions of Oracle Solaris and their workarounds (continued)
SPARC
CR ID M10-1
15825208 x
15826052 x
15840018 x
15851224 x
SPARC SPARC
M10-4 M10-4S Description
x x In SPARC M10 Systems, the
scp(1), sftp(1), and ssh(1)
commands of Oracle Solaris
may generate an error or
installation of Oracle RAC may
fail.
x x You cannot use the PCI hot plug
(PHP) function to add a Quad
Gigabit Ethernet card
(SE1X7GQ2F) to a PCI-Express
slot of a PCI expansion unit.
x x When the firmware is updated
to XCP2031 or later, the
following message is displayed
when starting Oracle Solaris.
NOTICE: skipping
unsupported token:
fjorclnum
x x When starting the I/O domain,
the following message may be
output and the panic may
persist.
recursive rw_enter,
lp=XXXXXXXX
wwwh=XXXXXXXX
thread=XXXXXXXX
Workaround
This has been modified with
Solaris 11.1 SRU1.4.
[Workaround]
For details, see "An error
occurs in executing the scp(1),
sftp(1), or ssh(1) command of
Oracle Solaris or the
installation of Oracle RAC fails
(CR:15825208)."
There is no effective
workaround.
Stop the logical domain to
which you want add the PCI
card before adding it.
There is no impact on the
system. Ignore this message.
Add the following to
/etc/system of the I/O domain
and restart Oracle Solaris:
forceload: drv/vpci
Note that if starting of the I/O
domain is disabled, you must
change to inactive state the
guest domain to which the
virtual disk (vdisk), which is a
target of the virtual disk
service (vds) of the I/O
domain, is assigned, with the
ldm stop-domain and ldm
unbind-domain commands.
This will enable starting of the
I/O domain. After starting the
I/O domain, set the above.
Chapter 3 Information on Software 41