Fujitsu M10 Product Notes page 40

Table 3-3
Problems resolved in versions prior to XCP 2043 (continue d)
SPARC
RTI No. M10-1
RTIF2-121113- x
014
RTIF2-121113- x
018
RTIF2-121113- x
019
RTIF2-121113- x
021
RTIF2-121113- x
022
RTIF2-121113- x
023
RTIF2-121113-
028
RTIF2-121113- x
027
Fujitsu M10/SPARC M10 Systems Product Notes for XCP Version 2043 ･ October 2013
28
SPARC SPARC
M10-4 M10-4S Description
x x The error message "/etc/redhat-
release not found" appears
while XSCF is starting.
x x When you replace a FRU with
the replacefru(8) command, the
message "configuration
changed (...)" showing a
configuration change may be
registered more than once in the
event log.
x x When the power supply of the
physical partition (PPAR) is
disconnected according to the
power supply schedule, "-" may
be displayed as a cause (Cause)
in the power log.
x x If time cannot be read
accurately due to a failed clock
in the XSCF board, an error
showing a clock failure may not
be recorded in the error log.
x x If the operation panel has failed
or is not connected, XSCF
cannot be started.
x x If a CPU failure occurs while
Hypervisor is running, the
physical partition (PPAR) is
reset more than once, and
restarting of the PPAR may take
time.
x x If you update the firmware and
then upload XCP with XSCF
Web without restarting XSCF,
uploading of XCP will fail and
the XSCF Web session will time
out.
Workaround
Ignore this message.
Ignore the message that appears
second time and later.
There is no effective workaround.
There is no effective workaround.
If the following message
appears when you execute the
poweron(8) command, the clock
in the XSCF board has failed.
Replace the XSCF board.
Poweron canceled due
to invalid system date
and time.
Connect the operation panel. If
the operation panel has failed,
replace it.
There is no effective workaround.
If you update the firmware and
then continue to upload XCP
with XSCF Web, restart XSCF.