Notes On Cpu Core Activation; Notes And Restrictions On Xscf Web - Fujitsu M10 Product Notes

command and restore them with the restoreconfig(8) command.

Notes on CPU core activation

If the XSCF setting information is initialized by executing the restoredefaults(8)
■
command in XCP 2032 or earlier, the information of the CPU core activation key is
also initialized.
When executing the restoredefaults(8) command, save the CPU core activation key
in advance before restoring it or register the key again.
If you execute the restoredefaults -c xscf command on XCP 2041 or later, the
■
information of the CPU core activation key is deleted not only from the XSCF unit
but also from the backup information in the XSCF. On the other hand, even if you
execute the restoredefaults -c factory command, the information of the CPU core
activation key is not deleted.
To initialize all settings to factory defaults including the information of the CPU
core activation key, use the -c factory -r activation option.
For the information of changes of the restoredefaults command, see
Revision of SPARC M10 Systems XSCF Reference
XSCF setting information saved by the dumpconfig(8) command contains CPU
■
core activation information and CPU core activation keys.
You can use the restoreconfig(8) command to restore CPU core activation
information and CPU core activation keys saved by the dumpconfig(8) command.
Therefore, if you configure CPU core activation or install a CPU core activation
key when configuring some settings for the XSCF, such as configuring an XSCF
network or physical partition (PPAR), it is recommended to save the CPU core
activation information and CPU core activation key by using the dumpconfig(8)
command. To save and restore only CPU core activation keys, execute the
dumpcodactivation(8) and restorecodactivation(8) commands, respectively. Note
that, however, these commands cannot save and restore CPU core activation
information. Use the showcod(8) and setcod(8) commands to reconfigure CPU
core activation.

Notes and restrictions on XSCF Web

Notes
(1) Common to browsers
When you import XCP or update firmware by using XSCF Web, "Session is
■
invalid" may appear on the web browser.
If the timeout of the XSCF shell is short when you import XCP by using XSCF
■
Web, XCP importing fails. Set the timeout of the XSCF shell to 30 minutes or
longer.
Select the [menu] tab and select [XSCF] - [Settings] - [Autologout] menu. Then,
enter a value of 30 minutes or greater in [Time-out value].
Manual."
Chapter 2 XCP 2043-Related Information
"Contents of
7