Fujitsu M10 Product Notes page 22

that does not exist may appear in an error log suspected area. This indicates that
an error was detected on the system board (PSB) while diagnosing. The output
PPAR-ID does not have any meaning.
We recommend to connect the control domain console via the XSCF-LAN port.
■
When a large amount of data is output by connecting to the control domain
console via a serial port, the data may not be displayed properly.
[SPARC M10-4S]
■
The time taken for processing a command that displays the system configuration
or status (such as showhardconf(8) command, showboards(8) command, and
showpparstatus(8) command) depends on the number of SPARC M10-4S cabinets
or crossbar boxes that configure the system.
[SPARC M10-4S]
■
If the system has multiple cabinets, BB#01 or XBBOX#81 cabinet may become the
master XSCF at first.
[SPARC M10-4S]
■
Depending on the system configuration, it may take time to reboot.
[SPARC M10-4S]
■
If you add a SPARC M10-4S to the SPARC M10-4S on which XCP 2032 is installed,
update to the latest firmware in advance.
Restrictions
Data input/output using SSH, HTTP, HTTPS, or FTP is not possible with the
■
following commands:
getflashimage(8), dumpconfig(8), restoreconfig(8), setremotepwrmgmt(8),
getremotepwrmgmt(8), dumpcodactivation(8), restorecodactivation(8), and
snapshot(8).
Use a USB device for data input and output.
However, in the following cases, data can be uploaded and downloaded from the
browser:
■
■
no-mem and no-io, which can be set by the -s option of the setpcl(8) command, are
■
not supported at present.
Alive monitoring between the XSCF and a Hypervisor is not supported. Alive
■
monitoring between the XSCF and a Hypervisor cannot be enabled/disabled even
by using the setpparmode(8) command.
[SPARC M10-4S]
■
Suppose that the XSCF was switched while connecting to the control domain
console in the SPARC M10-4S that is composed of more than two cabinets. In that
case, connection to the control domain console may not be established until all the
SPARC M10-4S cabinets have been restarted if an attempt has been made to
reconnect the control domain console to the switched master XSCF.
Fujitsu M10/SPARC M10 Systems Product Notes for XCP Version 2043 ･ October 2013
10
Importing XCP by selecting the [menu] tab in XSCF Web, and then selecting the
[XSCF]-[Firmware Update] menu
Saving a log by selecting the [menu] tab in XSCF Web, and then selecting the
[XSCF]-[snapshot] menu