Fujitsu M10 Product Notes page 29

Table 3-1
Problems that might occur with XCP 2043 and workarounds (continued)
SPARC
RTI No.
M10-1
RTIF2-130109- x
003
RTIF2-
130219-002
RTIF2-
130219-003
RTIF2-
130219-004
RTIF2- x
130219-006
SPARC SPARC
M10-4 M10-4S Description
x x If you use the setpcl(8)
command to change the LSB
number of a SPARC M10
system cabinet to which a PCI
expansion unit is connected and
start Oracle Solaris in the logical
domain configuration, you
cannot display the configuration
information of the PCI
expansion unit by executing the
showhardconf(8) command.
x When maintaining SPARC
M10-4S with a slave XSCF, if
you incorrectly connect the
standby XSCF and the slave
XSCF with an XSCF connection
cable, the maintenance is
considered to have finished
normally without detecting the
error.
x The following error log is
registered if you remove a XSCF
BB control cable when
removing a SPARC M10-4S
with the initbb(8) command or
replace a SPARC M10-4S or an
XSCF unit with the replacefru
(8) command.
Msg: Board control
error (MBC link error)
Msg: BB control cable
detected unexpected
Msg: XSCF hang-up is
detected
x When an error occurred with a
crossbar unit mounted on a
crossbar box, many copies of
"failed to read/write interrupt
mask register" may be
registered in the error log.
x x If you restart an XSCF by using
the flashupdate(8) or
rebootxscf(8) command while a
physical partition (PPAR) is
being powered on, the POST
may stop in a state where the
diagnosis is completed
(Initialization Complete).
Workaround
Use the setdomainconfig(8)
command to set the logical
domain configuration to the
"factory default", and power on
the physical partition (PPAR).
Then, configure the logical
domain again.
After switching between the
master XSCF and the standby
XSCF by using the switchscf(8)
command, execute the testsb(8)
command to the target slave
XSCF. The incorrect connection
with the XSCF connection cable
is detected and an error log is
issued.
There is no effective workaround.
Ignore the error log.
There is no effective workaround.
Power off the physical partition
(PPAR) and replace the crossbar
unit in the crossbar box.
Execute the reset por command,
or power off the PPAR by using
the poweroff -f command and
then power it on again.
Chapter 3 Information on Software 17