Device Paths Of Sparc M10-4S; When The Cpu Configuration At The Initial Implementation Is A - Fujitsu M10 Product Notes

17. Connect all power cords of the crossbar box and SPARC M10-4S to the input
power supply.
For details, see "5.2 Connecting Cable to SPARC M10-4/SPARC M10-4S" and "5.4
Connecting Cable to Crossbar Box."
18. Update the firmware to the same version as the master XSCF.
■
XSCF> getflashimage file:///media/usb_msd/images/XCPxxxx.tar.gz
XSCF> flashupdate -c update -m xcp -s version
■
XSCF> flashupdate -c sync

Device Paths of SPARC M10-4S

The following shows the device paths identified in SPARC M10-4S.
When the CPU configuration at the initial
implementation is a two-CPU
The following shows the device paths when the CPU configuration at the initial
implementation is a two-CPU.
Note - The following device paths are applied when the configuration is changed from a
two-CPU to a four-CPU.
I/O device paths in SPARC M10-4S cabinet
Table 6-1
I/O device paths in SPARC M10-4S cabinet (at initial implementation: a two-CPU)
Device
LSB#0 Internal SAS
Internal HDD#0
Internal HDD#1
Internal HDD#2
Internal HDD#3
Internal HDD#4
XCP 2040 or earlier
XCP 2041 or later
Device path
/pci@8000/pci@4/pci@0/pci@0/scsi@0
/pci@8000/pci@4/pci@0/pci@0/scsi@0/disk@p0
/pci@8000/pci@4/pci@0/pci@0/scsi@0/disk@p1
/pci@8000/pci@4/pci@0/pci@0/scsi@0/disk@p2
/pci@8000/pci@4/pci@0/pci@0/scsi@0/disk@p3
/pci@8000/pci@4/pci@0/pci@0/scsi@0/disk@p4
Chapter 6 Information on SPARC M10-4S Hardware 67