Fujitsu M10 Product Notes page 54

Table 3-4
Problems that might occur in any versions of Oracle Solaris and their workarounds (continue d)
SPARC
CR ID M10-1
15851441 x
Fujitsu M10/SPARC M10 Systems Product Notes for XCP Version 2043 ･ October 2013
42
SPARC SPARC
M10-4 M10-4S Description
x x When the memory fails and is
degraded, the following
message may be output at
startup of Oracle Solaris, and
the panic may persist.
tilelet_assign_fini_
cb(): tile 0xX in
memgrp X was unused
This may also occur when you
set the mirror mode for the
memory after saving the logical
domain setting with ldm
add-spconfig.
Workaround
Replace the memory having an
error.
If you want to start Oracle
Solaris while the memory
having an error remains to be
mounted, start it using the
following procedure from
XSCF.
1. Execute the poweroff(8)
command to turn off the
power of the physical
partitions (PPARs).
2. Execute the setdomainconfig
(8) command to restore
PPARs to their factory-
default state.
setdomainconfig -p
ppar_id -c default
3. Execute the poweron(8)
command to start the PPARs.
Oracle Solaris is started in the
factory-default configuration
which consists of only control
domains.
If you set the mirror mode for
the memory, configure a
logical domain after setting the
mirror mode in the factory-
default condition. Then, save
the settings with ldm
add-spconfig.
In addition, you must not
specify with ldm set-config or
the setdomainconfig(8)
command of XSCF the settings
that were saved with no mirror
mode set, to the environment
where the mirror mode is used.