Table of Contents
Advertisement
Chapter 8 Advanced Copy Management
8.2 Functions in the Action Area for Advanced Copy
The procedure to modify copy parameters is as follows:
Procedure
1
2
•
Registering the license for the Advanced Copy feature is required to use
SnapOPC+.
•
Make sure to set the notification method by using the procedure in
"11.2.7.1 Setup Event Notification" (page 550)
when the SDP usage exceeds the threshold.
•
Notification of the shortage of SDP capacity is sent only once for each
policy level. Even if the threshold is exceeded again within the 24 hours
from the first notification, the ETERNUS DX Disk storage system does
not report that effect. After 24 hours has passed, the device sends a
notification again.
•
If the threshold for multiple policies is satisfied at the same time, the
ETERNUS DX Disk storage system notifies of the highest policy level.
Click [Modify Copy Parameters] in [Action].
Specify the threshold for each policy level, and click the [Modify] button.
●
Policy of Snap Data Pool
•
Policy Level 1 (Informational) Threshold
If the usage of SDP exceeds the specified threshold, the ETERNUS DX Disk storage
system notifies that effect as the Policy Level 1 (Informational).
Specify between 1% and 97% for the threshold.
•
Policy Level 2 (Warning) Threshold
If the usage of SDP exceeds the specified threshold, the ETERNUS DX Disk storage
system notifies that effect as the Policy Level 2 (Warning).
Specify between 2% and 98% for the threshold.
•
Policy Level 3 (Error) Threshold
If the usage of SDP exceeds the specified threshold, the ETERNUS DX Disk storage
system notifies that effect as the Policy Level 3 (Error). Specify between 3% and 99%
for the threshold.
●
SDPE Setting
•
SDPE
Specify Snap Data Pool Element (SDPE), that is the unit of allocation to the SDV.
-
1GB
-
2GB
-
4GB
ETERNUS Web GUI User's Guide
Copyright 2011 FUJITSU LIMITED
216
to automatically report
P2X0-1090-02ENZ0
Advertisement
Table of Contents
