Table of Contents
Advertisement
Chapter 11 System Management
11.2 Functions in the Action Area for System
•
Thin Provisioning Pool Rate
Select whether to notify when the TPP usage changes (*1). When notifying, select the
notification method.
*1:
Notify when the TPP usage changes as follows:
-
From "Normal" to "Attention"
-
From "Normal" or "Attention" to "Warning"
-
The TPP capacity is exhausted
●
Warning Severity Level
Select whether to notify of a warning event for each event type.
•
Parts Warning
Select whether to notify when a warning level event occurs in a component other than
the drive. When notifying, select the notification method.
•
Disk Warning
Select whether to notify when a warning level event occurs in the drive for each condi-
tion shown below. When notifying, select the notification method.
-
Any Time
Notifies always when a warning level event occurs in the drive.
-
when HS<0
Notifies only when a warning level event occurs in the drive while available hot
spare disk is "Less than 0" (*1).
*1:
When rebuilding cannot be performed because there are no hot spares that can be
used as a substitute for the failed drive.
•
Temperature Warning
Select whether to notify when a temperature warning status is detected by the sensor.
When notifying, select the notification method.
•
Battery life Warning
Select whether to notify a battery expiration in advance (*1). When notifying, select the
notification method.
"Battery life Warning" notification is available only for ETERNUS DX410 S2/DX440 S2.
*1:
Advance notice of battery expiration is issued once "6 months before", once "a week
before", and once a day during the period from "6 days before" to "the expiration date".
•
Blink Fault LED at warning
Select "Enable" when setting the Fault LED in the front panel to blink while a warning
level event occurs, and select "Disable" when setting the Fault LED not to blink.
•
Turn on Fault LED when redundant copy is complete
Select "Enable" when setting the Fault LED of the drive to turn on while a warning level
event occurs, and select "Disable" when setting the Fault LED not to turn on.
●
Informational Level
Select whether to notify of an informational event for each event type.
•
Recovery module
Select whether to notify when the failed component is recovered by taking actions such
as replacement. When notifying, select the notification method.
ETERNUS Web GUI User's Guide
Copyright 2011 FUJITSU LIMITED
553
P2X0-1090-02ENZ0
Advertisement
Table of Contents
