Table of Contents
Advertisement
Chapter 9 Connectivity Management
9.2 Functions in the Action Area for Connectivity
3
4
9.2.3.8
Configure iSCSI Port
This function sets the connection information for the iSCSI ports that connect the ETERNUS DX
Disk storage system and the host or local and remote ETERNUS DX Disk storage systems.
•
If the Loop ID is changed while a PRIMEPOWER server or
SPARC Enterprise server is operating, reboot the server
immediately. If the parameters do not satisfy the input conditions,
an error screen appears.
•
If some parameters do not satisfy the input conditions, an error
screen appears.
Click the [OK] button.
→ Modification of the FC port parameters starts.
Click the [Done] button to return to the [Ports] screen.
When changing port parameters during operation, stop access from the
server that is allocated to the target port. Host access does not need to be
stopped to change the port parameters of newly added CA ports.
•
There are port modes for an iSCSI port; CA and RA. CA is used for
connecting to a server and RA is used for REC. To switch between "RA"
and "CA", refer to
value is "CA".
•
For the ETERNUS DX400 series, the ETERNUS DX8000 series, the
ETERNUS4000, and the ETERNUS8000, iSCSI-RA (for the connection
of older devices) is an iSCSI-RA adapter that is dedicated for REC.
•
For more details on iSCSI-CA parameter settings, refer to "User's Guide
-Server Connection-" for each OS type.
ETERNUS Web GUI User's Guide
Copyright 2011 FUJITSU LIMITED
"9.2.3.11 Modify Port Mode" (page
357
End of procedure
373). The default
P2X0-1090-02ENZ0
Advertisement
Table of Contents
