Table of Contents
Advertisement
Chapter 9 Connectivity Management
9.2 Functions in the Action Area for Connectivity
•
Alias Name
Enter the alias name of the target port.
While the iSCSI name is a formal nomenclature that specifies the target iSCSI port, an
alias name is used as nickname.
An alias name that is the same as another port cannot be specified.
The following input condition applies:
-
1 - 31 alphanumeric characters
●
General Settings
•
Transfer Rate
Select the transfer speed of the target port from the following:
-
Auto-negotiation
"100 Mbit/s (Full Duplex)" or "1 Gbit/s (Full Duplex)" is automatically selected for the
transfer rate.
-
100Mbit/s
100 Mbit/s (Full Duplex)
-
1Gbit/s
1 Gbit/s (Full Duplex)
•
MTU
Specify the MTU size of the target port.
"Maximum Transmission Unit (MTU)" is the maximum amount of data that can be
transmitted at the one time over the communication network.
-
1000bytes
-
1050bytes
-
1100bytes
-
1150bytes
-
1200bytes
-
1250bytes
-
1300bytes
-
1350bytes
-
1400bytes
-
1438bytes
•
Limit Band Width
Enter the bandwidth limit of the target port between 10 and 400 Mbit/s.
"Bandwidth limit" is used to limit the amount of data that is transferred via an iSCSI-RA
port.
●
Security
•
CHAP
Select "ON "to enable CHAP Authentication for the target port. Select "OFF" to disable
CHAP Authentication.
For CHAP authentication, an encrypted password based on a random key that the
ETERNUS DX Disk storage system receives from the host is sent, and connection
possibility is judged on the server side.
ETERNUS Web GUI User's Guide
Copyright 2011 FUJITSU LIMITED
366
P2X0-1090-02ENZ0
Advertisement
Table of Contents
