Table of Contents
Advertisement
Chapter 11 System Management
11.2 Functions in the Action Area for System
The procedure to set network environment is as follows:
Procedure
1
2
To enable or disable each service (such as HTTP and HTTPS), use the
procedure in
Click [Setup Network] in [Action].
Specify the parameters, and click the [Set] button.
•
Select Network Port
Select the port to configure from "MNT", "RMT", and "FST".
-
For ETERNUS DX80 S2/DX90 S2: MNT or RMT
-
ETERNUS DX410 S2/DX440 S2: MNT, RMT, or FST
•
Interface
-
Speed and Duplex
Select the communication speed and mode.
•
Auto-negotiation
•
1Gbit/s
•
100Mbit/s Half
•
100Mbit/s Full
•
10Mbit/s Half
•
10Mbit/s Full
-
Master CM IP Address
Enter the IP address for the Master CM of the ETERNUS DX Disk storage system
(required). (*1)
-
Slave CM IP Address
Enter the IP address for the Slave CM of the ETERNUS DX Disk storage system.
(*1)
The IP address of the Slave CM is used when an error occurs in the Master CM.
-
Subnet Mask
Enter the subnet mask of the ETERNUS DX Disk storage system (required). (*1)
-
Default Gateway
Enter the IP address of the Gateway. (*1)
-
Primary DNS
Enter the IP address of the Primary DNS server. (*1)
The Primary DNS server must be specified before the Secondary DNS server.
-
Secondary DNS
Enter the IP address of the Secondary DNS server. (*1)
-
Wake on LAN
Select whether to enable or disable the WOL function (*2).
*1:
Input numeric characters ("0" - "255") for all the text boxes.
*2:
The WOL function starts up the ETERNUS DX Disk storage system, which is connected to
LAN, from another server or a PC via network.
ETERNUS Web GUI User's Guide
Copyright 2011 FUJITSU LIMITED
"11.2.3.2 Setup Firewall" (page
459
462).
P2X0-1090-02ENZ0
Advertisement
Table of Contents
