Fujitsu Eternus web GUI User Manual page 460

For eternus dx90 s2; eternus dx80 s2; eternus dx410 s2; eternus dx440 s2
Table of Contents

Advertisement

Chapter 11 System Management
11.2 Functions in the Action Area for System
■ Supplementary Information
Allowed IP List
If the default gateway has been specified, the value entered on the "Allowed IP List"
becomes enabled.
Enter the IP address (or the network address) for the remote device and the subnet
mask.
Up to 16 addresses can be set.
Make sure to set the IP address (or the network address) and subnet mask in pairs.
When accessing of the ETERNUS DX Disk storage system from a different subnetwork
is not allowed
Specify the "IP Address" and the "Subnet Mask" of the ETERNUS DX Disk storage
system.
Only accessing from the same subnetwork is allowed.
When accessing of the ETERNUS DX Disk storage system from a different subnetwork
is allowed
Specify the "Default Gateway" and specify the "IP Address" (or the network address)
and the "Subnet Mask" for the "Allowed IP List".
(Setting Example) Allowed IP List
-
When accessing of the ETERNUS DX Disk storage system from a specific client
outside the subnetwork is allowed, specify the "IP Address" and the "Subnet Mask".
IP address: 10.20.30.40
Subnet Mask: 255.255.255.0
-
When accessing of the ETERNUS DX Disk storage system from a specific
subnetwork outside the subnetwork is allowed, specify the "Network Address" and
the "Subnet Mask".
IP address: 10.20.30.0
Subnet Mask: 255.255.255.0
When specifying the IP address or the subnet mask, note the
following:
-
Use "character strings in d.d.d.d format" to specify the IP
address
-
The IP address of the RMT port must be in a different
subnetwork from the MNT port
-
Specify the IP address of the Slave CM when connecting to
the Slave CM. The IP address of the Slave CM must be in the
same subnetwork as the Master CM
-
Specify the IP address of "Default Gateway" when allowing
access from outside of the subnetwork. The IP address must
be in the same subnetwork as the port
-
For "Allowed IP List", specify the IP address or the network
address that allows access to the ETERNUS DX Disk storage
system. These settings are not required for access from the
network address (same subnetwork) which the ETERNUS DX
Disk storage system belongs to
ETERNUS Web GUI User's Guide
Copyright 2011 FUJITSU LIMITED
460
P2X0-1090-02ENZ0

Advertisement

Table of Contents
loading

Table of Contents