Chapter 9 Connectivity Management
9.2 Functions in the Action Area for Connectivity
Host Response
Others
*1:
EMPD: ETERNUS Multipath Driver
The procedure to add a host response is as follows:
Procedure
1
2
Connection Environment
Name
This setting is for host
connection environments
that are not listed above.
Click [Add Host Response] in [Action].
Specify the host response name, set each parameter, and click the [Add] button.
•
There is a recommended host response pattern which has been
prepared for each OS type. Make sure to select the appropriate
recommended pattern. Refer to
Responses" (page 382)
•
When customizing the host response, make sure to create a new
host response using "Setting parameters".
●
Setting parameters
•
Name
Specify the host response name.
An existing host response name cannot be specified.
The following input conditions apply:
-
1 - 16 alphanumeric characters and symbols (except ", (comma)" and "?")
-
Space
ETERNUS Web GUI User's Guide
Copyright 2011 FUJITSU LIMITED
Byte-0 of Inquiry Response: No Conversion
(Default)
Inquiry VPD ID Type: Type1 + Type3 (Default)
Inquiry Standard Data Version: Version 5 (Default)
Command Timeout Interval: Default (25sec.)
Load Balance Response: Unit Attention (Default)
Reservation Conflict Response for Test Unit Ready:
Normal (Default)
Change Volume Mapping: No Report (Default)
Volume Capacity Expansion: No Report (Default)
Vendor Unique Sense Code: No Report (Default)
Host Specific Mode: Normal (Default)
Sense Data Conversion: No Conversion (Default)
For ETERNUS DX80 S2/DX90 S2:
Asymmetric / Symmetric Logical Unit Access:
ACTIVE-ACTIVE / PREFERRED_PATH (Default)
For ETERNUS DX410 S2/DX440 S2:
Asymmetric / Symmetric Logical Unit Access :
ACTIVE/ACTIVE
for details.
383
Settings
" Recommended Patterns of Host
P2X0-1090-02ENZ0