Table of Contents
Advertisement
Chapter 9 Connectivity Management
9.2 Functions in the Action Area for Connectivity
2
■ When the port mode is "CA"
Multiple selections can be made from FC ports that have the same
port mode. To set the same parameters to multiple ports, set the
parameters of the copy source port and click the [Copy] button.
Select the copy destination port and click the [Copy] button. The
parameters can be copied. Note that the "Loop ID" that is specified
for "Set Loop ID (Manual)" is not copied.
To set different parameters to multiple ports, select each target port
and set the parameters.
Set the parameters for all of the selected ports and click the [Set] button.
The settings of port parameters vary depending on the port mode.
•
Port
Select the target port or select the copy source port.
The location options for the selected port are displayed:
-
CM#x CA#y Port#z (x: CM number, y: CA number, z: Port number)
•
Connection
Select the connection method for the target port from the "Fabric" or "FC-AL".
When "FC-AL" is selected, it is necessary to assign a Loop ID to the port.
-
Fabric
A connection type that enables simultaneous communication among multiple nodes
through a fibre channel switch.
-
FC-AL
Multiple nodes are connected in a loop topology.
•
Set Loop ID
When the "Connection" is "FC-AL", select "Manual" or "Auto" to specify the Loop ID.
"Loop ID" is an identification number of a node in a loop.
•
Loop ID
-
Manual
When the "Set Loop ID" is "Manual", enter the Loop ID.
The Loop ID must have a value that is different from the values of all the ports
(including the host adapters) that are connected to the ETERNUS DX Disk storage
system.
The following input conditions apply:
•
0x00 - 0x7D
•
Up to 2-digit
-
Automatic
When the "Set Loop ID" is "Auto", select "Ascending" or "Descending".
•
Transfer Rate (Gbit/s)
Select the transfer speed.
-
Auto-negotiation
-
2 Gbit/s
-
4 Gbit/s
-
8 Gbit/s
ETERNUS Web GUI User's Guide
Copyright 2011 FUJITSU LIMITED
354
P2X0-1090-02ENZ0
Advertisement
Table of Contents
