ABB i-bus KNX Product Manual page 43


ABB i-bus KNX
Commissioning
Stop "Intermediate meter reading total"
on trigger 2
Options:
Note
This parameter is not available should Limit be selected beforehand.
•
no: The intermediate meter sends its meter reading at trigger 2 and continues to count further (without
reset).
•
yes: The intermediate meter uses its meter reading at trigger 2 and stops. The intermediate meter to-
tal can be restarted via the 1 bit communication object Receive trigger 1 or via the parameterzied time
Trigger 1 change time.
"Intermediate meter reading total"
additionally resettable per object
Options:
•
yes: The communication object Reset (Intermediate meter total) is enabled. When a telegram is re-
ceived with the value 1 on the communication object, the meter reading is sent and subsequently re-
set to zero. The status of the meter is not changed, i.e. if the meter is metering, it will continue to take
readings; if it is stopped, it will remain stopped.
Overwrite start-, stop time, duration
and limit with download or ETS reset
Options:
•
yes: After a download or ETS reset, the values changed on the bus are overwritten again with the pa-
rameter values.
•
no: After a download or ETS reset, the values changed on the bus are retained.
yes
no
no
yes
no
yes
SE/S 3.16.1 | 2CDC 505 084 D0203 41