Commissioning; Overview - ABB i-bus KNX Product Manual


ABB i-bus KNX

Commissioning

3 Commissioning
The ABB i-bus KNX Energy Actuator SE/S 3.16.1 is a switch actuator, which records the energy con-
sumers of the connected electrical loads. Its three outputs feature the same functions. It is thus possible,
depending on the application, to freely define every output and to parameterize it accordingly.
A short overview of all functions of the Energy Actuator can be found in the next chapter.
3.1

Overview

The following table provides an overview of the functions used by the Energy Actuator SE/S 3.16.1 and
those possible with the application program Switch Measure 3f.
Energy Actuator properties
Type of installation
Number of outputs
Module width
In rated current (A)
Manual operation
Switch on and off of the outputs (device front)
Switch position display (device front)
Parameterization options General
Cyclic monitoring telegram (In operation)
Limit number of telegrams
Request status values via 1 bit communication object
Request instrument values via 1 bit communication object
Request power values via 1 bit communication object
Instrument values send cycle time
Power values send cycle time
Parameterization options Metering (Wh)
Request meter readings via 1 bit communication object
Meter readings send delay
Meter readings send cycle time
Reset all meters via communication object
Enable meter reading total
SE/S 3.16.1
MDRC
3
4
16/20 A


SE/S 3.16.1







SE/S3.16.1





SE/S 3.16.1 | 2CDC 505 084 D0203 19