Parameter Window A: Monitor Current - ABB i-bus KNX Product Manual


ABB i-bus KNX
Commissioning
3.2.5.8.2

Parameter window A: Monitor current

In parameter window A: Monitor current, the parameters and the communication objects for the detection
and monitoring of the current value of output A are enabled.
Send "Current" after a change
Options:
•
yes: The value of the communication object Current value is sent after a change. The following para-
meter appears:
Send "Current" on request
Options:
•
yes: The value of the communication object Current value is sent when a telegram is received on the
communication object Request power values. This communication object is enabled in the parameter
window General, page 29 .
Send "Current" cyclically
Options:
•
yes: The value of the communication object Current value is sent cyclically. The setting of the cycle
time is undertaken in parameter window General, page 29 (parameter Cycle time for power values).
Cycle time and request objects are set
on "General"
<−−− NOTE
no
yes
Send "Current" when
+/- mA [1...20,000]
Options: 1...50...20.000
This parameter determines which changes of the value of the communication object Current value
are sent.
no
yes
no
yes
SE/S 3.16.1 | 2CDC 505 084 D0203 83