Siemens SINAMICS S120 Commissioning Manual page 200

Commissioning
5.7 Basic parameterization of the drive objects
Adding parameters to the exception list
Note
Parameters in the exception list can be read and modified
With activated know-how protection, parameters in the exception list can be read and modified
in other commissioning tools and in the web server. Therefore, do not add any critical
parameters to the exception list.
Proceed as follows to add individual parameters to the exception list:
1. Establish an online connection to your drive.
2. Call the parameter view of your drive.
3. In the parameter view, click on the icon
4. In the "<add new>" input field, enter the parameter number of the know-how protected
parameter to be excluded from know-how protection.
Parameters without know-how protection cannot be added to the exception list.
5. Confirm your entry with Return.
The most important parameter data is displayed in the exception list.
The changes in the exception list take effect immediately in online mode.
6. Repeat the process for all other parameters to be excluded from know-how protection.
7. To save the changes in the exception list retentively, click .
If you created the exception list in offline mode, load the project data into your drive
subsequently. The changes in the exception list take effect immediately when you switch to
online mode.
After the activation of know-how protection in online mode, only the parameters that were not
added to the exception list are know-how protected.
Removing parameters from the exception list
Proceed as follows to remove individual parameters from the exception list:
1. Establish an online connection to your drive.
2. Call the parameter view of your drive.
3. In the parameter view, click on the icon
4. In the exception list, select the parameter that you wish to remove from the exception list.
198
.
.
Commissioning with Startdrive
Commissioning Manual, 06/2020, 6SL3097-5AA10-0BP2