6.1.3.7
DRIVE-CLiQ Hub Module DMC20
Table 6-33
Description of the LEDs on the DRIVE-CLiQ Hub Module DMC20
LED
Color
READY
–
Green
Orange
Red
Green/red
Green/
orange
or
Red/
orange
Commissioning with Startdrive
Commissioning Manual, 06/2020, 6SL3097-5AA10-0BP2
Status
Description, cause
Off
The electronics power supply is missing or outside the permis‐
sible tolerance range.
Continu‐
The component is ready for operation. Cyclic DRIVE-CLiQ com‐
ous light
munication is taking place.
Continu‐
DRIVE-CLiQ communication is being established.
ous light
Continu‐
This component has at least one fault.
ous light
Note:
LED is controlled irrespective of the corresponding messages
being reconfigured.
Flashing
Firmware is being downloaded.
light 0.5
Hz
Flashing
Firmware download is complete. The system waits for POWER
light 2 Hz
ON.
Flashing
Component recognition via LED is activated (p0154 = 1).
light
Note:
Both options depend on the LED status when component rec‐
ognition is activated.
Diagnostics
6.1 Diagnostics using LEDs
Remedy
–
–
–
Remove and acknowl‐
edge the fault.
–
Carry out a POWER ON.
–
305