Siemens SINAMICS S120 Commissioning Manual page 323

Configuring recording conditions
To configure the recording conditions for a measurement, select the desired trigger condition in
the "Trigger mode" drop-down list in the 1st step. You then carry out the subsequent
configuration of the recording conditions depending on the selected trigger condition as
follows:
Figure 6-3
Trigger condition: Start recording immediately
1. Enter the recording time under "Recording duration". The maximum possible recording
duration is displayed to the right.
2. Should you wish to set the maximum recording time, activate the option "Use max. recording
duration".
3. Enter a recording cycle under "Cycle" The possible cycle settings depend on the number of
signals.
Commissioning with Startdrive
Commissioning Manual, 06/2020, 6SL3097-5AA10-0BP2
Example: Configuring recording conditions
Diagnostics
6.2 Diagnostics via Startdrive
321