Activating The Trace Recording; Deactivating The Trace Recording - Siemens SINAMICS S120 Commissioning Manual

Diagnostics
6.2 Diagnostics via Startdrive
6.2.2.4

Activating the trace recording

Overview
The following describes how you can activate a trace in the drive.
Requirements
• An online connection has been established to the drive.
• A trace is saved in the drive.
• The trace configuration in the drive is displayed in the working area (see Chapter "Creating or
calling a trace (Page 318)").
• The icon
Activating the trace recording
To activate the trace recording in the drive, click on the
The trace is activated in the drive and starts the recording corresponding to the configured
trigger condition.
The current status of the recording is displayed in the status display of the trace.
Note
When a recording is restarted, the previously recorded values are lost. To save the values that
have been recorded, save the measurement in the project (see Chapter "Saving a trace recording
in the project (Page 325)"), before you reactivate the recording.
6.2.2.5

Deactivating the trace recording

Overview
The following describes how you can deactivate a trace in the drive.
Requirements
• An online connection has been established to the drive.
• A trace is saved in the drive.
• The trace configuration in the drive is displayed in the working area (see Chapter "Creating or
calling a trace (Page 318)").
• The icon
324
for monitoring the displayed trace is enabled.
for monitoring the displayed trace is enabled.
icon.
Commissioning with Startdrive
Commissioning Manual, 06/2020, 6SL3097-5AA10-0BP2