Commissioning - Siemens SINAMICS S120 Commissioning Manual

Commissioning

Overview
You perform the commissioning of your SINAMICS S120 drive in the TIA Portal with the
integrated Startdrive engineering tool.
Requirements
• TIA Portal is installed on your PG/PC.
The version of the following software component applies exclusively to the current edition
of this documentation:
– TIA Portal V16 Update 1
• You have all of the required licenses to be able to use Startdrive in the TIA Portal without
restrictions (see "Ordering software (Page 35)").
The versions of the following software components apply exclusively to the current edition
of this documentation:
– SINAMICS Startdrive Advanced V16 Update 3
– SINAMICS Firmware V5.2.3
– SIMATIC STEP 7 Professional V16 (optional)
Commissioning workflow
You can commission a SINAMICS S120 drive in the following ways:
• Creating a project offline in Startdrive.
The components of the drive are combined offline in Startdrive.
• Loading the device configuration into the project.
The components of the drive are loaded into the project offline and supplemented as needed.
• Creating a project by reading out a device configuration.
The components of the drive are read out online and supplemented offline as needed.
Creating a project offline in Startdrive
The following steps are required when commissioning a drive:
1. Create a project with Startdrive (Page 100).
2. Perform the basic parameterization of the drive units (Page 180).
3. Establish an online connection to the drive. (Page 152)
4. Download the project to the target device (Page 242).
Commissioning with Startdrive
Commissioning Manual, 06/2020, 6SL3097-5AA10-0BP2
You require this software component only if you wish to configure a SINAMICS drive
together with a control system.
5
95