Calling The Destination And Transmitting The Document; Selecting The Communications Mode (For Optional 2Nd G3 Port Only) - NEC IT3510 Operation Manual

NEC IT Series
2.2
2.3
NEC IT3510/IT2510 Operations Manual

Calling the Destination and Transmitting the Document

Using the Automatic Document Feeder:
Ë
The NEC IT3510/IT2510 will begin dialing and sending the document as
soon as the first page is stored into memory. If the unit is transmitting a
previously stored document, or if the unit is currently receiving a
document, it will store your document into memory, until the previous
action is finished.
Using the Book Scanner:
Ë
Press <Start> after scanning all the pages of the document. As soon as
the <Start> key is pressed, dialing will begin.
Up to 64 documents can be stored in memory. If 64 documents have
Ë
already been stored, or if memory is full, no more pages can be stored.

Selecting the Communications Mode (For optional 2nd G3 Port only)

The communication mode is selected to send the document via a
Ë
specific facsimile port.
[G3-1] Select this port to send via G3 Port 1.
[G3-2] Select this port to send via G3 Port 2.
The communications mode returns to the default setting after each
Ë
transmission. Refer to Section 2.1 Transmission Settings in Chapter 4
Advanced Registration and Setting Operations on page 4-1.
Issue 1
5 - 5