NEC IT3510 Operation Manual page 455

NEC IT Series
The image
received at the
receiver is not
clear.
A blank sheet
is printed at the
receiving
station.
Automatic
transmission is
impossible.
TX Marker is
too light.
The received
image is not
clear.
NEC IT3510/IT2510 Operations Manual
Condition
The document is not set
correctly.
The scanning area is dirty.
The original document is too
light.
There is a problem with the
telephone line connection, or
with the receiving facsimile.
The document was placed face
down in the ADF.
The number is wrong.
The number is a voice number.
There is a problem at the
receiving end (such as, paper
out, toner out, memory full,
power off, etc.).
The Marker is becoming dry.
Condition
Approved print paper is not
being used.
The paper is damp.
Toner has run out.
There is a telephone line
problem, or with the sending
end.
Transmission (Continued)
Cause
Reception
Cause
Countermeasure
Set the document correctly.
Clean the scanning area.
Adjust the contrast that is
appropriate for the document.
Make a copy with this unit. If
the copy is clear, try to resent
the document to the receiver.
Place the document face up in
the ADF and resend.
Confirm the facsimile number.
Confirm the facsimile number.
Contact the receiving end and
check for trouble.
Replace the stamp.
Countermeasure
Only use quality copy paper.
Replace the paper supply.
Replace the toner bottle.
Make a copy on this unit. If
the copy is clear, contact the
sending side to check for
trouble.
Issue 1
8 - 31