Figure 6-1 Tx Marker Position - NEC IT3510 Operation Manual

Issue 1
6 - 20
Using the TX Marker (Continued)
6.
Press <Start>. Scanning and
transmission now begins.
i
The TX Marker setting returns to
the default status after each
transmission.
TX Marker Conditions:
When either the Real-Time Transmission or Manual Transmission function is
Ë
selected, a marker will stamp only on pages successfully transmitted.
When Quick Memory Transmission is selected, a marker is printed showing
Ë
that the document pages have successfully been scanned into memory. In
this case, refer to the Activity List or the Transmission Report to verify that the
transmission was successful.
Position of the TX Marker:
The TX Marker can be set to stamp the bottom of a page, or the top and
Ë
bottom of a page. Refer to Figure 6-1 TX Marker Position.
Refer to Section 2.1 Transmission Settings in Chapter 4 Advanced
Registration and Setting Operations on page 4-1.

Figure 6-1 TX Marker Position

Advanced Sending and Receiving Operations
NEC IT Series