Notes On Handling Documents; Figure 1-21 Using The Single Feed Tray - NEC IT3510 Operation Manual

NEC IT Series
• A document can also be placed in the 2-
Sided ADF in single sheet fashion
• The following functions cannot be used
when using the Single Feed Tray:
2-sided docum ents, 2-TO -1 function, B ook
S canner, S orting, Grouping, Stapling, C over
S heets, Page
C opying with the Bypass Tray, D irection of
the O riginal, and M argin
5.4
NEC IT3510/IT2510 Operations Manual
Insertion, D istribution,

Figure 1-21 Using the Single Feed Tray

Notes on Handling Documents

Please observe these important points concerning handling documents.
When Documents are placed in the ADF
Adjust the document guide plate(s) to the width of the document pages.
Ë
Remove all paper clips and staples from the documents.
Ë
If a document has cut-and-paste or taped attachments, only the Book
Ë
Scanner should be used. Scanning these pages in the ADF may cause
a jam condition or affect the image quality.
Do not use the ADF for scanning pages containing tape flags, as this
Ë
may cause a jam condition or affect image quality.
Ensure that any correction fluid or ink has dried before inserting the
Ë
pages into the ADF.
Do not open the Document Feed Cover while the ADF is in use. This will
Ë
cause the ADF scanning operation to be suspended.
Ensure that no pages are left on the Book Scanner glass. The ADF will
Ë
not operate with a page left on the Book Scanner glass.
When Documents are placed on the Book Scanner
Ensure that any correction fluid or ink has dried before inserting the
Ë
pages on the glass surface.
When scanning a book, or thick document, do not force the document
Ë
cover to close. Excessive force may cause damage to the door.
Ensure that no pages remain in the ADF. The Book Scanner will not
Ë
operate until these pages are removed.
Issue 1
Place the document to be
transmitted or copied face
down in the feeder
1 - 27