Replacing The Staple Cartridge; Figure 1-84 Removing A Staple Jam - NEC IT3510 Operation Manual

NEC IT Series
9.6
NEC IT3510/IT2510 Operations Manual
Clearing a Staple Jam
1. If a staple should jam, remove the staple holder. Refer to Installing and
Adding the Staple Cartridge on page 1-62.
2. Push the guide up on the staple holder to remove the sheet of staples.
The jammed staple can be removed.

Figure 1-84 Removing a Staple Jam

3. Replace the staple holder.
i
After a staple jam has been cleared, stapling may not occur for a maximum of 10
times, until the sheet of staples is brought into position.

Replacing the Staple Cartridge

The procedures listed next provide instructions for replacing the staple
cartridge in the Single-staple Finisher and the Multi-staple Finisher.
Single-staple Finisher
1.
Disconnect the finisher from the
main unit.
Issue 1
1 - 65