Toro Sand Pro 3040 Service Manual page 102

Test Procedure
Hydraulic System: Testing the Hydraulic System
position, the test results will be higher should not be used to determine wheel
motor efficiency. Test the wheel motors in three (3) different wheel positions to
obtain accurate test results. Record test readings for all three (3) wheel positions
and use the average for the final test result.
Special Equipment Required:
•
Flow meter with pressure gauge that has at least a 57 liters/minute (15
gallons/minute) capacity
•
Hydraulic test hose
•
Non-contact tachometer (phototach)
Refer to Traction Circuit Component Failure (page 5–5)
information regarding the importance of removing contamination
from the traction circuit.
1. Park the machine on a level surface, lower any attachments, and set the key
switch to the O position.
FF
2. Read and adhere to the information provided in
(page 5–23).
3. Ensure that the traction pedal is correctly adjusted for the N
refer to Adjusting the Traction System for Neutral (page
Review and follow the
the machine.
4. Raise the rear wheels off the ground and support the machine with jack
stands.
5. To test the front wheel motor:
A. Clean the hydraulic tube and hose above the front wheel; refer to
34.
IMPORTANT
WARNING
Jacking Instructions (page 1–6)
Page 5–32
for
Testing the Hydraulic System
position;
EUTRAL
5–52).
before lifting
Figure
Sand Pro ® 3040 and 5040
20251SL Rev A