Testing the Electrical Components
Electrical System: Testing the Electrical Components
For accurate resistance and/or continuity checks, electrically disconnect the
component being tested from the circuit (e.g., unplug the key switch connector
before doing a continuity check of the switch). Always check the item being
tested and the harness connector for damage or corrosion and clean or repair
if necessary.
Note: Refer to the
Briggs & Stratton V-Twin Engine Service Manual
engine electrical component repair information.
When testing the electrical components for continuity with a
multimeter (ohms setting), ensure that you disconnect the power to
the circuit.
IMPORTANT
Page 6–6
for additional
Sand Pro
®
3040 and 5040
20251SL Rev A