Hitch Assembly - Toro Sand Pro 3040 Service Manual

Hitch Assembly

Removing and Installing the Hitch Assembly
Chassis: Service and Repairs
g354858
1. Rear cover and manual tube assembly
2. cap screw (3 each)
3. Lift cylinder
4. Pivot pin
5. Pivot hub (2 each)
6. Flat washer (4 each)
7. Cap screw (4 each)
8. Flange bushing (2 each)
9. Grease fitting (4 each)
10. Flange bushing (4 each)
11. Hitch
Refer to Figure 100 for this procedure.
1. Park the machine on a level surface, lower any attachments, engage the
parking brake, set the key switch to the O
from the switch.
2. Remove any rear mounted attachments.
Figure 100
(shown with rear left wheel removed)
12. Hitch adapter
13. Pivot pin (2 each)
14. Clevis pin
15. Grease fitting
16. Bushing (2 each)
17. Roller tube
18. Flange nut (4 each)
19. Roller plate
20. Flat washer (4 each)
21. Cap screw (4 each)
FF
Page 7–22
position and remove the key
Sand Pro ® 3040 and 5040
20251SL Rev A