Toro Sand Pro 3040 Service Manual page 131

Filtering the Closed-loop Traction Circuit (continued)
g349444
1. Right side rear wheel motor
2. Hydraulic tube
Sand Pro ® 3040 and 5040
20251SL Rev A
If using a hydraulic filter that is not bidirectional, install the filter
with the flow direction toward the traction pump for a traction pump
failure, and toward the wheel motors for a wheel motor failure.
5. Connect the Toro high flow hydraulic filter in series between the disconnected
fittings and tube or hose. Use the hydraulic hose kit to connect the filter to
the machine if necessary; refer to
that all hydraulic connections are properly tightened.
6. Fill the hydraulic tank with the correct type and quantity of new hydraulic
fluid; refer to the traction unit Operator's Manual.
7. Start engine and run at low idle speed. Check for and correct any hydraulic
leaks before proceeding.
Use extreme caution when performing this test. The traction unit
wheels will be rotating during the test.
Figure 48
3. Left side rear wheel motor
4. Hydraulic tube
IMPORTANT
Hydraulic Hose Kit (page
CAUTION
Page 5–61
2–15). Ensure
Hydraulic System: Service and Repairs