Steering Cylinder (Model 08745) - Toro Sand Pro 3040 Service Manual

Steering Cylinder (Model 08745)

g351128
1. Retaining ring
2. Washer (2 each)
3. Yoke
4. Cap screw (2 each)
5. Washer (2 each)
Removing the Steering Cylinder
Hydraulic System: Service and Repairs
6. Spacer (2 each)
7. Bushing (2 each)
8. Grease fitting
9. Retaining ring
10. Steering cylinder
Refer to Figure 67 for this procedure.
1. Park the machine on a level surface, lower any attachments, engage the
parking brake, set the key switch to the O
from the switch.
2. Read and adhere to the information provided in
Removing and Installing the Hydraulic System Components (page
3. Clean the fitting and hydraulic hose connections before disconnecting the
hydraulic hoses to prevent system contamination.
4. Disconnect the hydraulic hoses. Cap the fittings and plug the hoses to
prevent system contamination.
5. Remove the 2 jam nuts that secure the steering cylinder ball joint to the
front fork.
6. Use a suitable tool (pickle fork) to separate the ball joint from the front fork.
7. Remove the 2 cap screws and flat washers that secure the steering cylinder
to the yoke and remove the cylinder from the machine. Locate and retrieve
the spacers.
Figure 67
11.
12.
13.
FF
Page 5–102
Elbow fitting (2 each)
Ball joint
Jam nut (2 each)
position and remove the key
General Precautions for
5–54).
Sand Pro ® 3040 and 5040
20251SL Rev A