Toro Sand Pro 3040 Service Manual page 115

Test Procedure (continued)
Sand Pro ® 3040 and 5040
20251SL Rev A
A. Park the machine on a level surface, lower any attachments, and engage
the parking brake.
B. With the engine running, turn the steering wheel to the right (clockwise)
until the steering cylinder rod is fully extended and set the key switch
to the O position.
FF
C. Read and adhere to the information provided in
System (page 5–23).
D. Clean the hydraulic fitting and hydraulic hose at the rod end of the
steering cylinder. Disconnect and plug the hydraulic hose.
g355374
1. Elbow fitting at steering cylinder rod end
E. With the engine not running, continue turning the steering wheel to the
right (clockwise). Monitor the hydraulic fluid at the open fitting on the
steering cylinder as the steering wheel is turned to the right.
If oil comes out of the fitting while turning the steering wheel to the
right, the steering cylinder has internal leakage and should be repaired
or replaced; refer to
Servicing the Steering Cylinder (Model 08745) (page
5. If a steering problem exists and the steering cylinder tested acceptably, the
steering control valve may require repair or replacement; refer to
Control Valve (Model 08745) (page 5–99)
Valve (Model 08745) (page
6. After testing:
A. Connect the hydraulic hose.
B. Check and adjust the level of the hydraulic fluid in the hydraulic reservoir;
refer to the traction unit Operator's Manual.
C. Start the engine and operate the steering system. Check for any
hydraulic fluid leaks. Repair hydraulic leaks if necessary before returning
the machine to service.
Figure 41
2. Hydraulic hose – plugged
Steering Cylinder (Model 08745) (page 5–102)
or
5–101).
Page 5–45 Hydraulic System: Testing the Hydraulic System
Testing the Hydraulic
5–104).
Steering
Servicing the Steering Control
or