Removing and Installing the Traction Relief Manifold (continued)
Hydraulic System: Service and Repairs
7. If the hydraulic fittings are to be removed from the manifold, mark the fitting
orientation for assembly purposes and remove the fittings from the manifold.
Discard the O-rings from the fittings.
8. If the hydraulic fittings were removed from the manifold, lubricate new O-rings
with clean hydraulic fluid, position the O-rings to the fittings, and install the
fittings in the marked orientation; refer to
(SAE Straight Thread O-Ring Fittings) (page
9. Secure the manifold assembly to the bracket with the previously removed
fasteners.
10. Remove the caps and plugs then connect the hydraulic hoses to the manifold
fittings; refer to
Installing Hydraulic Hoses and Tubes (O-Ring Face Seal
Fitting) (page
5–7).
11. Charge the hydraulic system; refer to
5–64).
Installing the Hydraulic Fittings
Charging the Hydraulic System (page
Page 5–84
5–9).
Sand Pro
®
3040 and 5040
20251SL Rev A