Traction Pedal And Control Assembly - Toro Sand Pro 3040 Service Manual

Traction Pedal and Control Assembly

g349747
1. Forward pedal
2. Pad – forward
3. Neutral arm
4. Thrust washer
5. Bearing
6. Traction stud
7. Extension spring
8. Cap screw
9. Damper
10. Cap screw – (neutral switch target) 21.
11. Plate
Removing Traction Pedal and Control Components
Chassis: Service and Repairs
12. Traction neutral switch
13. Adjustment pin
14. Pump plate
15. Cap screw (3 each)
16. Shoulder bolt
17. Rubber bushing (2 each)
18. Pump input cam
19. Cap screw
20. Rod end
Jam nut
22. Traction rod
Refer to Figure 93 for this procedure.
1. Park the machine on a level surface, lower any attachments, engage the
parking brake, set the key switch to the O
from the switch.
2. Remove the center shroud from the machine.
3. Disconnect the traction rod assembly from the traction pedal and the pump
input cam. Remove the traction rod from the machine and discard the cotter
pin.
4. Remove the damper.
Figure 93
23.
24.
25.
26.
27.
28.
29.
30.
31.
32.
FF
Page 7–10
Flat washer (2 each)
Traction pedal assembly
Cotter pin
Flange lock nut (2 each)
Pedal stop
Spacer
Wave washer
Plain washer
Cap screw
Pad – reverse
position and remove the key
Sand Pro ® 3040 and 5040
20251SL Rev A