Installing the Rear Lift Cylinder
Sand Pro
®
3040 and 5040
20251SL Rev A
Refer to
Figure 62
for this procedure.
1. If the hydraulic fittings were removed from the cylinder, lubricate new O-rings
with clean hydraulic fluid, position the O-rings to the fittings, and install the
fittings in the marked orientation; refer to
(SAE Straight Thread O-Ring Fittings) (page
2. Secure the barrel end of the lift cylinder to the frame with the previously
removed fasteners.
3. Install the pin to secure the lift cylinder clevis to the hitch and secure the pin
with the previously removed fastener.
4. Lubricate the grease fitting on the cylinder clevis with #2 general purpose
grease.
5. Remove the caps and plugs then connect the hydraulic tubes to the cylinder
fittings; refer to
Installing Hydraulic Hoses and Tubes (O-Ring Face Seal
Fitting) (page
5–7).
6. Charge the hydraulic system; refer to
5–64).
Installing the Hydraulic Fittings
Charging the Hydraulic System (page
Page 5–95
5–9).
Hydraulic System: Service and Repairs