Toro Sand Pro 3040 Service Manual page 237

Removing Traction Pedal and Control Components (continued)
Installing Traction Pedal and Control Components
Sand Pro ® 3040 and 5040
20251SL Rev A
The extension spring is under tension. Use caution when removing
the spring to avoid personal injury.
5. Loosen the adjustment pin lock nut to allow the extension spring to relax.
Unhook the spring from the neutral arm.
6. Disassemble the remaining traction pedal and control components as
necessary.
Refer to Figure 93 for this procedure.
1. Assemble the traction pedal and control components as necessary.
• Apply #2 general purpose grease to the traction stud prior to assembly.
• If the pump input cam was removed, apply medium strength thread locking
compound to the clamping screw prior to installation.
• If the pump plate was removed, tighten the fasteners that secure the pump
plate to the piston pump from 15 to 24 N·m (11 to 18 ft-lb).
The extension spring is under tension. Use caution when installing
the spring to avoid personal injury.
2. Install the extension spring and tighten the adjustment pin lock nut until 4.6
to 11.0 mm (0.18 to 0.43 inch) of the adjustment pin threads extend beyond
the lock nut.
g349781
1. Extension spring
2. Neutral arm
3. Install the damper.
CAUTION
CAUTION
Figure 94
3. Adjustment pin
4. Lock nut
Page 7–11 Chassis: Service and Repairs