Front Fork - Toro Sand Pro 3040 Service Manual

Front Fork

Removing the Front Fork (Model 08743)
g354744
1. Front fork
2. Flange nut (2 each)
3. Slotted nut
4. Cotter pin
Chassis: Service and Repairs
5. Washer
6. Bearing cone (2 each)
7. Bearing cup (2 each)
8. Cap screw (2 each)
1. Remove the steering gear box; refer to
(page 7–14).
2. Remove the front wheel; refer to
3. Remove the hose guide from the front fork. Carefully position the hydraulic
hoses away from the fork.
4. Remove the front fork from the machine:
A. Support the front fork to prevent it from falling.
B. Remove and discard the cotter pin, then remove the slotted hex nut that
secures the front fork to the frame.
C. Lower the front fork from the machine.
D. Locate and retrieve the washer.
5. Remove the bearing cones and the bearing spacer.
6. Clean and inspect the bearing cups and cones for wear or damage and
replace the bearings if necessary.
Figure 98
10.
Removing the Steering Gear Box
Removing the Front Wheel (page
Page 7–18
9. Hose guide
Spacer
Sand Pro ®
20251SL Rev A
7–3).
3040 and 5040