Toro Sand Pro 3040 Service Manual page 135

Charging the Hydraulic System (continued)
Sand Pro ® 3040 and 5040
20251SL Rev A
9. For model 08745 machines, turn the steering wheel in both directions so that
the steering cylinder moves in and out several times.
10. Operate the traction pedal in the forward and reverse directions. Make sure
the wheels are turning in the proper direction. If the traction (piston) pump
or a wheel motor was replaced or rebuilt, operate the traction circuit slowly
for 10 minutes.
11. Ensure that the traction pedal returns to the N
and adjust if necessary; refer to the traction unit Operator's Manual.
12. Stop the machine, check the hydraulic components for leaks and tighten
any loose connections.
13. Check and adjust the fluid level in the hydraulic tank if necessary; refer to
the traction unit Operator's Manual.
Note: If new fluid shows any signs of contamination, flush the hydraulic
system again until the fluid is clean; refer to
(page 5–57).
14. Operate the machine for 2 hours under normal operating conditions.
15. Check and adjust the fluid level in the hydraulic tank if necessary; refer to
the traction unit Operator's Manual.
Note: If new fluid shows any signs of contamination, flush the hydraulic
system again until the fluid is clean; refer to
(page 5–57).
Page 5–65
position when released.
EUTRAL
Flushing the Hydraulic System
Flushing the Hydraulic System
Hydraulic System: Service and Repairs