Toro Sand Pro 3040 Service Manual page 137

Removing the Hydraulic Tank (continued)
Installing the Hydraulic Tank
Sand Pro ® 3040 and 5040
20251SL Rev A
5. Remove the left rear wheel from the machine; refer to
Installing the Rear Wheels (page
6. Read and adhere to the information provided in
Removing and Installing the Hydraulic System Components (page
7. Clean the hydraulic hose ends and fittings on the hydraulic tank before
disconnecting the hoses to prevent contaminating the hydraulic system.
To prevent damage to the hydraulic hoses and tubes, cable ties and
clamps may be used to secure the hoses and tubes to the machine
components. Record the location of all cable ties and clamps that
are removed from the machine so they can be properly replaced.
8. For assembly purposes, label all the hydraulic connections. Loosen the hose
clamps and disconnect the hoses from the hydraulic tank.
9. Cap or plug the hydraulic fittings and hoses to prevent contamination from
entering the hydraulic system.
10. Remove the 3 clamps that secure the hydraulic tank to the machine.
11. Remove the hydraulic tank from the machine.
12. If hydraulic fittings are to be removed from the hydraulic tank, mark the fitting
orientation to allow for correct assembly before removing the fittings.
Refer to Figure 49 for this procedure.
1. If any of the hydraulic fittings were removed from the tank, use new O-rings
and tighten the fittings to the correct torque:
• 1-5/8 inch plug = 81 to 100 N·m (60 to 74 ft-lbs)
• 1-1/16 inch fitting = 23 to 28 N·m (17 to 21 ft-lbs)
• 3/4 inch plug or fitting = 23 to 28 N·m (17 to 21 ft-lbs)
2. Position the hydraulic tank in the machine and secure the tank to the machine
with the 3 previously removed clamps.
3. Remove any caps or plugs from the hydraulic lines and fittings and connect
the hydraulic lines to the tank.
4. Install a new hydraulic fluid filter; refer to the traction unit Operator's Manual.
5. Charge the hydraulic system; refer to
5–64).
6. Install the left rear wheel; refer to
(page 7–5).
7. Install the center shroud.
7–5).
IMPORTANT
Charging the Hydraulic System (page
Removing and Installing the Rear Wheels
Page 5–67
Removing and
General Precautions for
5–54).
Hydraulic System: Service and Repairs